Tank Anchor Archives

Who is qualified to verify if a tank vent pipe can support a fall arrest load?

Posted on February 5, 2026

A Qualified Person: typically a structural engineer: must perform a structural analysis of the vent pipe and its connection to the tank. Many older vent pipes were not designed to handle a 5,000 lb dynamic load.

What happens if a worker falls while attached to a clamp-on tank anchor?

Posted on February 5, 2026

The system is designed to arrest the fall: but the dynamic force can put immense stress on the vent pipe. After any fall: the anchor and the tank structure must be inspected by a Qualified […]

How do environmental factors like tank venting gases affect anchor safety?

Posted on February 5, 2026

Corrosive gases can degrade standard steel. We recommend high-grade stainless steel or specialized coatings and require annual visual inspections to ensure the clamp’s structural integrity hasn’t been compromised.

What are the hazards of using a tank anchor on a steeply sloped tank roof?

Posted on February 5, 2026

If the tank roof pitch exceeds 18.4 degrees (4/12 pitch): the risk of a sliding fall increases significantly. In these cases: a Fall Arrest (FA) system is mandatory to ensure the worker is stopped before they […]

Can multiple workers use the same tank anchor simultaneously?

Posted on February 5, 2026

Our Rail and Trolley systems can be engineered for multiple users in restraint: but the system must be specifically rated and labeled for the number of concurrent users allowed.

Why is a “hot work” permit avoided with this system?

Posted on February 5, 2026

Because the anchor clamps on: there is no need for welding: grinding: or spark-producing activities. This is a critical safety advantage in refineries and chemical plants where volatile vapors may be present.