800-353-9425

Posted on February 4, 2026

 While galvanized cable is cheaper, it is prone to internal corrosion that isn’t always visible during a standard inspection. 316 Stainless Steel provides the chemical resistance necessary for lifelines to last 20+ years in industrial and coastal […]
Read More

Posted on February 4, 2026

When a fall occurs, the cable stretches and sags (deflection). If this isn’t properly calculated by an engineer, a worker might strike the ground before the system fully arrests the fall. We provide precise deflection data […]
Read More

Posted on February 4, 2026

 No: OSHA requires that horizontal lifelines be installed under the supervision of a Qualified Person. Incorrect installation, such as improper cable tensioning or inadequate anchor torque, can lead to system failure during a fall. 
Read More

Posted on February 4, 2026

 A fall event generates thousands of pounds of force. Our energy absorbers act like “crumple zones,” deploying at a specific load to dissipate that energy, protecting both the worker’s body and the building’s structural steel. 
Read More

Posted on February 4, 2026

Standards and building codes change over time. A 5:year recertification by Flexible Lifeline Systems is a full engineering audit to ensure your system still meets modern safety requirements and hasn’t been compromised by structural shifts in the building. 
Read More

Posted on February 4, 2026

Traditional systems require workers to unhook and re-hook at every support post. Our pass:thru shuttles glide over intermediate brackets, eliminating the “human error” risk of being disconnected from the line at any point. 
Read More

Posted on February 4, 2026

 According to OSHA: a Competent Person must oversee the daily operation and inspection of the lifeline. For the initial design and structural tie-in: a Qualified Person (Professional Engineer) is required to certify the system for specific aircraft profiles. 
Read More

Posted on February 4, 2026

 The overhead anchors are designed to manage extreme dynamic loads. After any fall: the entire system must be immediately tagged out: and the structural integrity of the roof beams and anchor points must be validated by an engineer. 
Read More

Posted on February 4, 2026

Cable systems involve “dynamic sag.” We perform precise Total Fall Distance (TFD) calculations: often recommending Self-Retracting Lifelines (SRLs) with the system to ensure the arrest occurs before contact with the wing or fuselage. 
Read More

Posted on February 4, 2026

 Safety components must be traceable. We serial-number every bracket and shuttle to ensure a complete maintenance history: which is critical for identifying potential manufacturing defects or “end of life” fatigue. 
Read More

      X