Posted on July 26, 2021
Fixed ladder, temporary ladders, stairs and manlifts are all potentially safe methods of accessing a roof. A job hazard analysis should be performed to ensure the access can be done in a safe manner. If […]
Read More
Posted on February 4, 2026
No, the system uses anti-slip rubber pads to distribute weight evenly. This prevents point-loading and protects delicate surfaces like TPO or EPDM from abrasion or compression damage.
Read More
Posted on February 4, 2026
While the 200 lb requirement is the legal minimum, our systems are engineered with a safety factor. However, if a significant impact occurs, the system must be inspected for “grub screw” slippage or post deformation before […]
Read More
Posted on February 4, 2026
Yes, per OSHA 1910.28, any gap in a guardrail system used for ladder access must be protected by a self-closing gate or an offset (swing gate) to prevent a worker from accidentally stepping backward into […]
Read More
Posted on February 4, 2026
While aluminum is lightweight, our hot-dip galvanized steel systems offer superior impact resistance and are treated to ASTM A153 standards to prevent “white rust” and deep oxidation in salt-air environments.
Read More
Posted on February 4, 2026
Yes, under OSHA definitions, a freestanding guardrail is considered a permanent fall protection solution as long as it meets the load requirements and is intended to remain in place for the life of the hazard.
Read More
Posted on February 4, 2026
While the modular design is straightforward, we recommend installation by factory-trained technicians to ensure all fittings are torqued to specification and the counterweight layout matches the original safety engineering plan.
Read More